Locate R/O CONN as close to the front of the cabinet as possible. Use self drilling screws provided, to attach R/O CONN in a horizontal or vertical position. Use 1/4" food grade polyethylene tubing on all connections.

When adding icemaker and tank valve kits to the 1/4" FSD-JG model. Use 3 wraps of 1/2" Teflon tape on the 1/4" IPS threads.

Do not overtighten plastic threads. Tighten until valve will not rotate freely on stainless steel mounting plate when handle is turned.

When servicing the reverse osmosis unit, turn off all ball valves. If not using a tank valve kit, make sure to turn off storage tank valve on storage tank. Open reverse osmosis system spigot to relieve pressure in tubing. Remove system from under sink by disconnecting it from R/O CONN using push-in fittings, (see diagram at right). Make sure to use drain plug provided to seal the drain. Use red caps provided to seal ends of tubing. Follow manufacturer's instructions for filter/membrane replacement. If equipped with tank valve kit, storage tank can remain attached to R/O CONN. Follow manufacturer's instructions for proper air pre charge and sanitation. Storage tank can be flushed with tap water by attaching a 12" piece of tubing to tap water feed valve and tank valve. Fill storage tank, then detach tube from tap water feed valve and attach to spigot connector. This is the fastest way to drain the storage tank. If you don't have a tank valve kit, use tank line to drain by disconnecting it from the reverse osmosis system. Once installed you need no tools to install or remove reverse osmosis system. Expansion kits are available from your water treatment dealer. R/O CONN is made from the best materials available to give you years of trouble free operation. R/O CONN is made to be used repeatedly and requires no maintenance other than a little silicone lubricant on the o-rings to help tubing slide in and out easily.

Permanent Connection Side

We recommend that your water treatment dealer or a licensed plumber make the permanent connections to this side. Check with your state plumbing code guide lines or refer to the reverse osmosis system manufactures installation instructions.

Maximum operating pressure 125 PSI.
All water fittings are NSF listed.
All components and specifications are subject to change without notice.

R/O CONN has a limited warranty against defects in materials and workmanship for the period of 1 year from original date of purchase. R/O CONN is not responsible for damages of any kind, including incidental and consequential damage. Some states do not allow the exclusion or limitation of incident or consequential damages, so the above exclusion and limitation may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

For more information write us at:
R/O CONN
7000 N. 16th ST. Ste.105
Phoenix, Arizona 85020
or phone (602) 432-5402

Or Email us at:roinfo@roconn.com

Copyright © 1998 R/O CONN. All Rights Reserved
U.S. Patent # 5,660,720